If you are a user This TX111 Multifunction Printer Epson Catridge problems are not detected and Catridge slowly back into place, do not be confused. Please try the tips in this post I have time, maybe can help .......Catridge Slow Back into place
This condition is caused by the flow of electricity to the cartridge pins disconnected, try to check on the main board looking for F1 and F2 (F = Fuse) Fuse F1 and F2 is a fuse-shaped or R (resistor). check using AVO meter / Multitester, if Scala show good fuse is connected and if it means showing off Fuse replace it with another or replace with R (resistor) with a small value.
This condition is caused by the flow of electricity to the cartridge pins disconnected, try to check on the main board looking for F1 and F2 (F = Fuse) Fuse F1 and F2 is a fuse-shaped or R (resistor). check using AVO meter / Multitester, if Scala show good fuse is connected and if it means showing off Fuse replace it with another or replace with R (resistor) with a small value.
Port scanner
If the scanner removed the scanner will not work and the indicator light blinking. If the scanner is installed and the printer can not deteck catridge then the power indicator light and the ink indicator lights up. so scaner printer for the above case is normal and no problems on the scanner
If the scanner removed the scanner will not work and the indicator light blinking. If the scanner is installed and the printer can not deteck catridge then the power indicator light and the ink indicator lights up. so scaner printer for the above case is normal and no problems on the scanner
Good luck ......
No comments:
Post a Comment